Skip to content
Victorian terraces in Sydney's Inner West with overhead service lines from a street pole

Inner West Level 2 Electrician

Old mains, a sagging laneway line or a reno that needs the power cut? Call a local Inner West Level 2 electrician and get a free written quote.

Accredited Level 2 ASP work on the Ausgrid network from Balmain to Strathfield: consumer mains, overhead and underground service lines, private poles, three phase upgrades and disconnections for renovations. We deal with Ausgrid so you don't have to.

Get a free quote

Takes a minute. A local level 2 electrician will call you back.

No obligation. Your details only go to one local level 2 electrician.

  • Accredited Level 2 ASP
  • 24/7 emergency call-outs
  • Free written quotes

How an Inner West Level 2 job runs

  1. Tell us about the jobFill in the form or call. Size, finish and timing all help.
  2. A local level 2 electrician calls youYour enquiry goes to one level 2 electrician who works in your area.
  3. Get your quote on siteThey measure up and quote. There’s no obligation to go ahead.
Trench with electrical conduit across a cottage garden for an underground power connection

Level 2 work for the Inner West’s oldest streets

If you need an Inner West level 2 electrician, you’re probably dealing with something between the street and your meter board: old consumer mains, a service line that’s too low, a rotten pole in the laneway, or a renovation that needs the power isolated at the network. That part of your supply can’t be switched off at your main switch, and it can’t be touched by just any electrician. It needs an accredited Level 2.

That’s all we do. We work on the Ausgrid network across the Inner West, from the harbourside streets of Balmain and Birchgrove to the Federation homes of Haberfield, Ashfield and Strathfield, and we deal with Ausgrid’s paperwork so you don’t have to.

What we do

Why the Inner West keeps us busy

The Inner West has some of the oldest housing in Sydney, and its electricity supply shows it. A lot of homes still have consumer mains from the 1940s to 1960s, run in rubber-insulated cable that cracks and crumbles with age. Most streets are still fed by overhead mains, with service lines crossing front gardens, footpaths and rear laneways. Blocks are small, lanes are narrow and the street trees are big, so lines get hit by branches, trucks and scaffolding more often than in newer suburbs.

Then there’s renovation. Second storeys on terraces, rear extensions on cottages and knockdown rebuilds in Concord and Five Dock nearly always affect the supply: the point of attachment ends up in the wrong place, the mains are too small for the new kitchen, or the builder needs the power off and site power on.

Signs you need a Level 2

  • Lights dim when the air conditioner or oven starts
  • Your meter box feels warm or has scorch marks
  • The overhead line sags, sits low over the driveway or has been hit
  • A pole in your yard or laneway leans or is soft at the base
  • You’ve had a defect notice from Ausgrid
  • Your builder, roofer or electrician has told you the supply needs to be isolated
  • Your house has no power but the neighbours do

Not sure if you need a Level 2 or a regular electrician? Our guide do I need a level 2 electrician explains the difference, and our guide to VIR consumer mains shows what old cable looks like.

How a job runs

Every job starts with a free look, either on site or from photos for simple jobs. We tell you what’s needed, what Ausgrid requires and what it will cost, in writing. Then we book a date that suits you and any other trades, lodge the notification with Ausgrid, and do the work. Most jobs take a day or less. You get a certificate of compliance at the end.

Terraces, heritage areas and laneways

Big parts of the Inner West sit in heritage conservation areas, so we plan routes for mains and conduit that keep the front of the house tidy, and we place new brackets and raisers as discreetly as the rules allow. In laneway terraces, where the supply often comes in at the back, we plan around rear access, shared poles and neighbours who might be affected by a disconnection.

Across the Inner West

We work in every Inner West suburb, including level 2 electrician Leichhardt, level 2 electrician Marrickville, level 2 electrician Balmain, level 2 electrician Ashfield and level 2 electrician Drummoyne. If your suburb isn’t listed, call anyway: chances are we were in your street last month.

Free written quotes

Tell us what’s going on and we’ll give you a fixed written price. No obligation, and no surprises on the day.

Inner West suburbs we cover

Pick your suburb for local detail, or just call. We cover the whole Inner West.

Show all 54 suburbs

Inner West Level 2 questions

Something else on your mind? Call 0473 522 769 and ask.

Which councils do you cover?

We work across Inner West Council, the City of Canada Bay, Burwood, Strathfield and the inner western parts of the City of Sydney.

Is the Inner West on Ausgrid or Endeavour Energy?

The Inner West is supplied by Ausgrid, so all our Level 2 work here is lodged with Ausgrid.

Do you work in apartment blocks?

Our Inner West work is mostly houses, terraces and small blocks of flats. For larger strata buildings, call us to talk through what's needed.

How do I know if my consumer mains are VIR?

VIR cable has a black rubber-and-cloth outer that turns hard and crumbly with age. You often see it where the mains enter the meter board. If you're not sure, we can check it on a free visit without touching anything live.

Will I be without power for long?

Most consumer mains upgrades in a terrace or cottage are done in one working day. The power is off while the old cable comes out and the new one goes in, and back on before we leave.

Do I need a new switchboard as well?

Not always. If the switchboard is old, has ceramic fuses or no safety switches, it is worth doing at the same time, but the consumer mains can be replaced on their own.

Need a Level 2 electrician in the Inner West?

📞 Call now Free quote