Skip to content
Meter box on a terrace verandah with new consumer mains and old VIR cable removed
Level 2 electrical

Consumer Mains Upgrade Inner West

New consumer mains from the point of attachment to your meter board, sized for how your home uses power today.

Get a free quote

Takes a minute. A local level 2 electrician will call you back.

No obligation. Your details only go to one local level 2 electrician.

Consumer mains are the cables that carry power from where the network connects to your house (the point of attachment on the wall or the pit at the boundary) to your meter board and main switch. Everything in the house depends on them. In the Inner West, a lot of these cables are older than the people living in the house, and many were never sized for air conditioning, induction cooktops, EV chargers or a second bathroom.

Why Inner West mains wear out

Most Inner West terraces and Federation cottages were wired, or rewired, between the 1940s and the 1970s. Mains from that era were often run in VIR cable, which has rubber insulation that dries out, cracks and falls away. Others are in early PVC that is simply too small. You find them run through hot roof spaces, along verandah ceilings to a front meter box, or down rear walls next to a laneway, where they have had decades of heat, sun and the odd possum.

Signs your mains need attention include:

  • Lights that dim when the air conditioner or oven starts
  • A meter board that feels warm, smells hot or shows scorch marks
  • Cracked, black, crumbly insulation where the cable enters the meter board
  • An electrician or Ausgrid telling you the mains are undersized for a new appliance

Our guide to VIR consumer mains explains what old cable looks like and why it matters.

What a consumer mains upgrade involves

We start by tracing the existing cable from the point of attachment or boundary pit to the meter board. That tells us the cable size, the route and what is fixed to it along the way. We then size the new mains for your current and planned load, with room to spare if you are thinking about a pool, an EV charger or three phase power.

On the day, we lodge the notification with Ausgrid, isolate the supply and pull the old cable out. The new mains go in along the best available route, which in a terrace might be the same roof space, a new conduit down the side passage or a cleaner path to a relocated meter board. Both ends are terminated, the installation is tested and the power is reconnected. You get a certificate of compliance for the work.

Moving the point of attachment or meter board

Many Inner West homes have their service line attached in an awkward spot: low on the front facade, across a neighbour’s roof, or on a rear wall the laneway trucks keep clipping. A mains upgrade is the right time to fix that. If the attachment needs to move or be raised, we combine the job with a point of attachment upgrade. If you’d rather lose the overhead line altogether, an overhead to underground conversion can replace both the service line and the mains in one go.

Heritage conservation areas cover big parts of Leichhardt, Annandale, Balmain and Haberfield. Moving a meter box on a front facade may need council’s view, so we plan routes that keep visible changes to a minimum.

Renovations and extensions

If you’re adding a rear extension, a second storey or a granny flat, your builder will often find the existing mains can’t carry the extra load. We work with your builder and electrician so the new mains, meter position and switchboard all line up with the plans, and we can do the power disconnection and reconnection the build needs as part of the same job.

Book a free mains check

If your mains are old, warm or undersized, call your local Inner West level 2 electrician for a free look and a fixed price. We work across the area, including level 2 electrician Leichhardt and Marrickville jobs every week.

Updated

The price depends on the length of the cable run, whether the mains go through a wall cavity, roof space or conduit, the meter board position and any heritage constraints. We look on site and give you a fixed written price.

What good consumer mains upgrade looks like

Close-up of consumer mains upgrade on a home in the Inner West area
What consumer mains upgrade looks like up close on a typical Inner West area home.
Signs that consumer mains upgrade needs attention
Typical signs that it needs attention.

Consumer Mains Upgrade questions in the Inner West

Something else on your mind? Call 0473 522 769 and ask.

How do I know if my consumer mains are VIR?

VIR cable has a black rubber-and-cloth outer that turns hard and crumbly with age. You often see it where the mains enter the meter board. If you're not sure, we can check it on a free visit without touching anything live.

Will I be without power for long?

Most consumer mains upgrades in a terrace or cottage are done in one working day. The power is off while the old cable comes out and the new one goes in, and back on before we leave.

Do I need a new switchboard as well?

Not always. If the switchboard is old, has ceramic fuses or no safety switches, it is worth doing at the same time, but the consumer mains can be replaced on their own.

Consumer Mains Upgrade in the Inner West: step by step

  1. Check the existing mainsWe trace the cable from the point of attachment to the meter board, check its size and insulation, and look at the switchboard it feeds.
  2. Plan the new runWe work out the cable size for your load, the route and whether the meter board or point of attachment should move.
  3. Disconnect, replace, reconnectWe isolate the supply, pull in the new consumer mains and terminate both ends, usually in a single day.
  4. Test and certifyWe test the installation, reconnect to the Ausgrid network and give you the certificate of compliance.

Need a Level 2 electrician in the Inner West?

📞 Call now Free quote